Add Ethernet Ports To A Vlan - Huawei Quidway S3500 Series Operation Manual

Operation Manual - VLAN
Quidway S3500 Series Ethernet Switches
Table 1-1 Enable/Disable VLAN feature
Enable/Disable VLAN feature
By default, VLAN feature is enabled on the switch.
Note that you will see error prompt when creating VLAN after VLAN feature is disabled.
S3526E/S3526C switches support the configuration in S3500 series switches.
1.2.2 Create/Delete a VLAN
You can use the following command to create/delete a VLAN.
Perform the following configurations in system view.
Table 1-2 Create/Delete a VLAN
Create a VLAN and enter the VLAN view
Delete the specified VLAN
If the VLAN to be created exists, enter the VLAN view directly. Otherwise, create the
VLAN first, and then enter the VLAN view.
vlan_id specifies the VLAN ID. Note that the default VLAN, namely VLAN 1, cannot be
deleted.

1.2.3 Add Ethernet Ports to a VLAN

You can use the following command to add the Ethernet ports to a VLAN.
Perform the following configuration in VLAN view.
Table 1-3 Add Ethernet ports to a VLAN
Add Ethernet ports to a VLAN
Remove Ethernet ports from a VLAN
By default, the system adds all the ports to a default VLAN, whose ID is 1.
Operation
Operation
Operation
Huawei Technologies Proprietary
1-2
Chapter 1 VLAN Configuration
Command
vlan { enable | disable }
Command
vlan vlan_id
undo vlan { vlan_id [ to vlan_id ] | all }
Command
port interface_list
undo port interface_list