Enable/Disable Cluster Function; Enter Cluster View - Huawei Quidway S3500 Series Operation Manual

Operation Manual - Integrated Management
Quidway S3500 Series Ethernet Switches

Enable/Disable cluster function

Enter cluster view

Configure cluster IP address pool
Name the administrator device and cluster.
Add/delete a cluster member device
Setup a cluster automatically.
Member accessing
Set cluster holdtime.
Set cluster timer to specify the handshaking message interval.
Configure FTP/TFTP Servers and Logging/SNMP Hosts for a Cluster.
Note:
You need to enable the cluster function and configure cluster parameters on an
administrator device. However, you only have to enable the cluster function on the
member devices and Candidate devices.
2.4.2 Enable/Disable Cluster Function
Enable the cluster function before using it.
Perform the following configuration in system view.
Table 2-13 Enable/Disable cluster function
Enable cluster function.
Disable cluster function.
Above commands can be used on any device supporting the cluster function. When
you use the undo cluster enable command on an administrator device, the system will
delete the cluster and disable the cluster function on it. When you use it on a member
device, the system will exit the cluster and disable the cluster function on it.
By default, the cluster function is enabled.
2.4.3 Enter cluster view
You must enter cluster view before configure the cluster function.
Perform the following configuration in system view.
Operation
Huawei Technologies Proprietary
2-12
Chapter 2 HGMP V2 Configuration
Command
cluster enable
undo cluster enable