Configuring An Interval Required For Sending Lsu Packets; Setting An Interval For Lsa Retransmission Between Neighboring Routers - Huawei Quidway S3500 Series Operation Manual

Operation Manual - Routing Protocol
Quidway S3500 Series Ethernet Switches
Table 4-10 Setting a dead timer for the neighboring routers
Configure
neighboring routers
Restore the default dead interval of the
neighboring routers
By default, the dead interval for the neighboring routers of p2p or broadcast interfaces
is 40 seconds and that for the neighboring routers of p2mp or nbma interface is 120
seconds.
Note that both hello and dead timer will restore to the default values after the user
modify the network type.

4.2.11 Configuring an Interval required for sending LSU packets

Trans-delay seconds should be added to the aging time of the LSA in an LSU packet.
Setting the parameter like this mainly considers the time duration that the interface
requires for transmitting the packet.
The user can configure the interval of sending LSU message. Obviously, more attention
should be paid on this item over low speed network.
Perform the following configuration in Interface view:
Table 4-11 Configuring an Interval required for sending LSU packets
Configure an interval for sending LSU packets
Restore the default interval of sending LSU
packets
By default, the LSU packets are transmitted per second.
4.2.12 Setting an Interval for LSA Retransmission between Neighboring
Routers
If a router transmits an LSA (Link State Advertisements) to the peer, it requires the
acknowledgement packet from the peer. If it does not receive the acknowledgement
packet within the retransmit, it will retransmit this LSA to the neighbor. The value of
retransmit is user-configurable.
Perform the following configuration in Interface view:
Operation
a dead timer for
Operation
Huawei Technologies Proprietary
4-11
Chapter 4 OSPF Configuration
Command
the
ospf timer dead seconds
undo ospf timer dead
ospf trans-delay seconds
undo ospf trans-delay
Command