Typical Bgp Configuration Example - Huawei Quidway S3500 Series Operation Manual

Operation Manual - Routing Protocol
Quidway S3500 Series Ethernet Switches
Display the information on BGP routes
which is mapped to a certain regular
expression
Display
information
Enable information debugging of all
BGP packets
Enable BGP event debugging
Enable BGP Keepalive debugging
Enable BGP Open debugging
Enable BGP packet debugging
Enable BGP Update packet debugging
Enable information debugging of BGP
normal functions.
Enable BGP Update packet debugging
Reset BGP flap information

5.4 Typical BGP Configuration Example

5.4.1 Configuring BGP AS Confederation Attribute
I. Networking requirements
Divide the following AS 100 into three sub-AS: 1001, 1002, and 1003, and configure
EBGP, confederation EBGP, and IBGP.
Operation
configured route-policy
Huawei Technologies Proprietary
5-25
Chapter 5 BGP Configuration
Command
display bgp
regular-expression
as-regular-expression
display route-policy [ policy-name ]
debugging bgp all
debugging bgp event
debugging bgp keepalive [ receive |
send ] [ verbose ]
debugging bgp open [ receive | send ]
[ verbose ]
debugging bgp packet [ receive |
send ] [ verbose ]
debugging bgp
[ receive | send ] [ verbose ]
debugging bgp normal
debugging bgp update [ receive |
send ] [ verbose ]
reset bgp
[ regular-expression
as-regular-expression
acl-number | network-address [ mask ] ]
routing-table
route-refresh
flap-info
| as-path-acl