Configure Gvrp; Gvrp Overview - Huawei Quidway S3000-EI Series Operation Manual

Operation Manual - VLAN
Quidway S3000-EI Series Ethernet Switches
N ote that, the value of Join timer should be n
a nd the value of L
s maller than the Leaveall timer value. Otherwise, the system will prompt message of
error.
By default, Hold timer is 10 centiseconds, Join timer is 20 centiseconds, Leave timer is
60 centiseconds, and LeaveAll timer is 1000 centiseconds.
3.1.3 Disp lay a nd Debug GARP
After the above configuration, execute display command in any view to display the
running of GARP configuration, and to verify the effect of the c
reset command in user view
command in user view to deb
Table 3-2 Display and debug GARP
Display GARP statistics information
Display GARP timer
Clear GARP st
Enable GARP event debugging
Disable GARP event debugging
3.2 Conf igure GVRP

3.2.1 GVRP Overview

GARP VLAN Registration Protocol (GVRP) is a GARP application. Based on GARP
operating mechanism,
information in the switch and prop
GVRP-supporting switches can receive VLAN registration information from other
switches and dyn
active members and through which port those members can be reached. All the
GVRP-supporting switches can propagate their local VLAN registration information to
other switches so that the VLAN information can be consistent on all GVRP-supporting
devices in one switching network. The VLAN registration information propagated by
GVRP includes both the local static registration information configured manually and
the dynamic registration information from other switches.
eave timer should be grea
to reset the configuration of GARP. Execute debugging
ug the configuration of GARP.
Operation
atistics info rmation
GVRP provides maintenance of the dynamic VLAN registration
agates the information to other switches. All the
amically update the local VLAN registration information including the
Huawei Technologies Proprietary
3-3
Chapter 3 GARP/GVRP Configuration
o less than the doubled value of
ter than the doubled value o
onfiguration. Execute
Command
display garp statistics [ interface
interface-list ]
display garp timer
interface-list ]
reset garp statistics
interface-list ]
debugging garp event
undo debugging garp event
Hold timer,
f Join timer and
[ interface
[ interface