Portal Configuration Tasks - Huawei Quidway S3500 Series Operation Manual

Operation Manual - Security
Quidway S3500 Series Ethernet Switches
The Portal servers are installed and configured. For the installation and configuration,
refer to Comprehensive Access Management Server Portal User Manual.
Note:
For DHCP configurations, refer to Quidway S3500 Series Ethernet Switches
Operation Manual.
For the AAA and RADIUS configurations, refer to the following chapter.

2.2.2 Portal Configuration Tasks

The following table describes Portal configuration tasks.
Table 2-1 Port configurations
Enter the system view
Configure Portal servers
Configure
operating modes
Configure authentication
network segments
Time intervals for ARP
handshaking with user
PCs and the maximum
number
handshake to fail
Enter the VLAN interface
view
Steps
system-view
portal
server-name
ip-address
key-string | port port |
url url-string } *
Portal portal method { direct
| redhcp | layer3 }
portal
network-address
net-mask vlan vlan_id
portal arp-handshake
{ interval interval |
retry-times
of times for
retry-times }*
interface
vlan-interface vlan_id
Huawei Technologies Proprietary
Command
—
Required. By default, no
Portal server is configured.
server
{ When a Portal server is
ip
|
configured,
key
key-string is Huawei, port is
50,100, and url-string is an IP
address character string.
Optional. By default, Portal
operating mode is direct
authentication.
When
operating mode as Layer 3
Portal
must
auth-network
command. When others are
configured for the Portal
operating mode, you do not
need
command.
Optional. This task is only
valid for direct authentication
and re-DHCP authentication.
By default, the time interval
for ARP handshake is 60
seconds, and the maximum
number
handshake to fail is 5.
—
2-5
Chapter 2 Portal Configuration
Description
by default,
configuring Portal
authentication,
configure
to configure
of times
you
this
this
for