Pim-Dm Configuration Example - Huawei Quidway S3500 Series Operation Manual

Operation Manual - Multicast
Quidway S3500 Series Ethernet Switches

6.3 PIM-DM Configuration Example

I. Networking requirements
Lanswitch1 has a port carrying Vlan 10 to connect Multicast Source, a port carrying
Vlan11 to connect Lanswitch2 and a port carrying Vlan12 to connect Lanswitch3.
Configure to implement multicast between Multicast Source and Receiver 1 and
Receiver 2.
II. Networking diagram
Multicast Multicast
Source Source
Figure 6-2 PIM-DM configuration networking
III. Configuration procedure
This section only introduces Lanswitch1 configuration procedure, while Lanswitch2 and
Lanswitch3 configuration procedures are similar.
# Enable the multicast routing protocol.
[Quidway] multicast routing-enable
# Enable PIM-DM.
[Quidway] vlan 10
[Quidway-vlan10] port ethernet 0/2
[Quidway-vlan10] quit
[Quidway] vlan 11
[Quidway-vlan11] port ethernet 0/3
[Quidway-vlan11] quit
[Quidway] vlan 12
[Quidway-vlan12] port ethernet 0/4
[Quidway-vlan12] quit
[Quidway] interface vlan-interface 10
[Quidway-vlan-interface10] ip address 1.1.1.1 255.255.0.0
VLAN 10 VLAN 10 VLAN11 VLAN11
Lanswitch1 Lanswitch1
VLAN12 VLAN12
Huawei Technologies Proprietary
Chapter 6 PIM-DM Configuration
VLAN20 VLAN20
Lanswitch2 Lanswitch2
VLAN30 VLAN30
Lanswitch3 Lanswitch3
6-5
RECEIVER 1 RECEIVER 1
RECEIVER 2 RECEIVER 2