Displaying And Debugging Info-Center; Configuration Examples Of Sending Log To Unix Loghost - Huawei Quidway S3500 Series Operation Manual

Operation Manual - System Management
Quidway S3500 Series Ethernet Switches
By default, the log, debugging and trap information synchronization switch of master in
Fabric are all turned on. The log, debugging and trap information synchronization
switch of other switches are turned on.

4.5.10 Displaying and Debugging Info-center

After the above configuration, performing the display command in any view, you can
view the running state of the info-center. You also can authenticate the effect of the
configuration by viewing displayed information. Performing the reset command in user
view, you can clear statistics of info-center.
Perform the following operation in user view. The display command still can be
performed in any view.
Table 4-48 Displaying and debugging info-center
Display the content of information channel
Display configuration of system log and
memory buffer
Clear information in memory buffer
Clear information in trap buffer

4.5.11 Configuration examples of sending log to Unix loghost

I. Networking Requirement
The networking requirement are as follows:
Sending the log information of the switch to Unix loghost
The IP address of the loghost is 202.38.1.10
The information with the severity level above informational will be sent to the
loghost
The output language is English
The modules that allowed to output information are ARP and IP
Operation
Huawei Technologies Proprietary
4-27
Chapter 4 System Maintenance and Debugging
Command
display channel [ channel-number
| channel-name ]
display info-center
reset logbuffer
reset trapbuffer