Configure Cluster Ip Address Pool; Name Administrator Device And Cluster - Huawei Quidway S3500 Series Operation Manual

Operation Manual - Integrated Management
Quidway S3500 Series Ethernet Switches
Table 2-14 enter cluster view
enter cluster view.

2.4.4 Configure Cluster IP Address Pool

Before setting up a cluster, you are supposed to configure a private IP address pool.
When a Candidate device is added, the administrator device will dynamically assign a
private IP address, which can be used for communication inside the cluster. In this way,
you can use the administrator device to manage and maintain the member devices.
Perform the following configuration in cluster view.
Table 2-15 Configure cluster IP address pool
Configure cluster IP address pool.
Restore the default IP address pool of
the cluster.
Before setting up a cluster, the user should configure a private IP address pool for the
member devices of the cluster.
Note that, the above configuration can only be performed on administrator device, and
must be configured before the cluster is build. The IP address pool of an existing
cluster cannot be modified.

2.4.5 Name Administrator device and Cluster

Every cluster has a name.
Perform the following configuration in cluster view.
Table 2-16 Name the administrator device and cluster.
Name Administrator device and Cluster.
Remove all the member devices from the cluster and
configure the administrator device as a Candidate device.
This command can only be used on an administrator device. When executed on an
administrator device to configure a different cluster name, the command can be used to
rename the cluster.
Operation
Operation
Operation
Huawei Technologies Proprietary
2-13
Chapter 2 HGMP V2 Configuration
Command
cluster
Command
ip-pool administrator-ip-address { ip-mask
| ip-mask-length}
undo ip-pool
Command
build name
undo build