Huawei Quidway S3500 Series Operation Manual page 454

Operation Manual - STP
Quidway S3500 Series Ethernet Switches
Table 1-18 Configure the port (not) to connect with the point-to-point link
Configure
point-to-point link.
Configure the port not to connect with the
point-to-point link.
Configure MSTP to automatically detect if the port
is directly connected with the point-to-point link.
Configure MSTP to automatically detect if the port
is directly connected with the point-to-point link, as
defaulted.
II. Configure in Ethernet port view
Perform the following configuration in Ethernet port view.
Table 1-19 Configure the port (not) to connect with the point-to-point link
Configure the port to connect with the
point-to-point link.
Configure the port not to connect with the
point-to-point link.
Configure MSTP to automatically detect if the
port is directly connected with the point-to-point
link.
Configure MSTP to automatically detect if the
port is directly connected with the point-to-point
link, as defaulted.
You can configure the port (not) to connect with the point-to-point link with either of the
above-mentioned measures. For more about the commands, refer to the Command
Manual.
For the ports connected with the point-to-point link, upon some port role conditions met,
they can transit to forwarding state fast through transmitting synchronization packet,
thereby reducing the unnecessary forwarding delay. If the parameter is configured as
auto mode, MSTP will automatically detect if the current Ethernet port is connected with
the point-to-point link.
Operation
the port to connect
Operation
Huawei Technologies Proprietary
1-22
Chapter 1 MSTP Region-configuration
with the stp interface
point-to-point force-true
stp interface
point-to-point force-false
stp interface
point-to-point auto
undo
interface-list point-to-point
Command
stp point-to-point force-true
stp point-to-point force-false
stp point-to-point auto
undo stp point-to-point
Command
interface-list
interface-list
interface-list
stp interface