Gvrp Configuration Example - Huawei Quidway S3500 Series Operation Manual

Operation Manual - VLAN
Quidway S3500 Series Ethernet Switches
Table 3-6 Display and debug GVRP
Display GVRP statistics information
Display GVRP global status information
Enable GVRP packet or event debugging
Disable GVRP packet or event debugging

3.2.6 GVRP Configuration Example

I. Networking requirements
To dynamically register and update VLAN information among switches, GVRP needs to
be enabled on the switches.
II. Networking diagram
Sw itch A Sw itch A
Figure 3-1 GVRP configuration example
III. Configuration procedure
Configure Switch A:
# Enable GVRP globally.
[Quidway] gvrp
# Set Ethernet0/10 as a Trunk port and allows all the VLANs to pass through.
[Quidway] interface ethernet0/10
[Quidway-Ethernet0/10] port link-type trunk
[Quidway-Ethernet0/10] port trunk permit vlan all
# Enable GVRP on the Trunk port.
[Quidway-Ethernet0/10] gvrp
Configure Switch B:
Operation
E0/10 E0/10
E0/11 E0/11
Sw itch B Sw itch B
Huawei Technologies Proprietary
3-6
Chapter 3 GARP/GVRP Configuration
Command
display gvrp statistics [ interface
interface-list ]
display gvrp status
debugging gvrp { packet | event}
undo debugging gvrp { packet |
event }