Huawei Quidway S3500 Series Operation Manual page 38

Operation Manual - Getting Started
Quidway S3500 Series Ethernet Switches
Note:
By default, the password is required for authenticating the Modem and Telnet users
when they log in. If the password has not been set, when a user logs in, he will see the
prompt "Login password has not been set !".
If the authentication-mode none command is used, the Modem and Telnet users will
not be required to input password.
II. Setting the command level used after a user logging in
The following command is used for setting the command level used after a user logging
in.
Perform the following configuration in local-user view.
Table 4-15 Setting the command level used after a user logging in
Set a service type for the specified user (For
S3552 series, S3528 series, S3526E series
and S3526C)
Cancel the service type of the specified user
(For S3552 series, S3528 series, S3526E
series and S3526C)
Set a service type for the specified user (For
S3526, S3526 FM and S3526 FS)
Cancel the service type of the specified user
(For S3526, S3526 FM and S3526 FS)
By default, the specified logon user can access the commands at Level 1.
III. Setting the command level used after a user logs in from a user interface
You can use the following command to set the command level after a user logs in from
a specific user interface, so that a user is able to execute the commands at such
command level.
Perform the following configuration in user interface view.
Operation
Huawei Technologies Proprietary
4-8
Chapter 4 User Interface Configuration
Command
service-type { ftp [ ftp-directory
directory ] | lan-access | { ssh |
telnet }* [ level level ] }
undo service-type
[ ftp-directory ] | lan-access | { ssh
| telnet }* [ level level ] }
service-type { ftp [ ftp-directory
directory ] | lan-access | telnet
[ level level ] }
undo service-type
[ ftp-directory ] | lan-access | telnet
[ level level ] }
{
ftp
{
ftp