Huawei Quidway S3500 Series Operation Manual page 35

Operation Manual - Getting Started
Quidway S3500 Series Ethernet Switches
out, he cannot log in again. In this case, a user can log in to the switch through the user
interface only when the terminal service is enabled again.
Table 4-8 Enabling/disabling terminal service
Enable terminal service
Disable terminal service
By default, terminal service is enabled on all the user interfaces.
Note the following points:
For the sake of security, the undo shell command can only be used on the user
interfaces other than AUX user interface.
You cannot use this command on the user interface via which you log in.
You will be asked to confirm before using undo shell on any legal user interface.
II. Configuring idle-timeout
Table 4-9 Configuring idle-timeout
Configure idle-timeout
Restore the default idle-timeout
By default, idle-timeout is enabled and set to 10 minutes on all the user interfaces. That
is, the user interface will be disconnected automatically after 10 minutes without any
operation.
idle-timeout 0 means disabling idle-timeout.
III. Locking the user interface
This configuration is to lock the current user interface and prompt the user to enter the
password. This makes it impossible for others to operate in the interface after the user
leaves.
Table 4-10 Locking the user interface
Lock user interface
Operation
Operation
Operation
Huawei Technologies Proprietary
4-5
Chapter 4 User Interface Configuration
Command
shell
undo shell
Command
idle-timeout minutes [ seconds ]
undo idle-timeout
Command
lock