Snmp Configuration Example - Huawei Quidway S3500 Series Operation Manual

Operation Manual - System Management
Quidway S3500 Series Ethernet Switches
Display the version character string of the
system

5.5 SNMP Configuration Example

I. Networking requirements
Network Management Station and the Ethernet switch are connected via the Ethernet.
The IP address of Network Management Station is 129.102.149.23 and that of the
VLAN interface on the switch is 129.102.0.1. Perform the following configurations on
the switch: setting the community name and access authority, administrator ID, contact
and switch location, and enabling the switch to sent trap packet.
II. Networking diagram
129.102.149.23
NMS
Figure 5-2 SNMP configuration example
III. Configuration procedure
# Enter the system view.
<Quidway> system-view
# Set the community name , group name and user.
[Quidway] snmp-agent sys-info version all
[Quidway] snmp-agent community write public
[Quidway] snmp-agent mib include internet 1.3.6.1
[Quidway] snmp-agent group v3 managev3group write internet
[Quidway] snmp-agent usm v3 managev3user managev3group
# Set the VLAN interface 2 as the interface used by network management. Add port
Ethernet 0/3 to the VLAN 2. This port will be used for network management. set the IP
address of VLAN interface 2 as 129.102.0.1.
[Quidway] vlan 2
[Quidway-vlan2] port ethernet 0/3
[Quidway-vlan2] interface vlan 2
Operation
129.102.0.1
Ethernet
Huawei Technologies Proprietary
display
version
5-9
Chapter 5 SNMP Configuration
Command
snmp-agent sys-info