Configuring Default Cost For The Imported Route; Setting The Rip Preference - Huawei Quidway S3500 Series Operation Manual

Operation Manual - Routing Protocol
Quidway S3500 Series Ethernet Switches
Table 3-11 Configuring RIP to import Routes of Other Protocols
Configure RIP to import routes of other
protocols
Cancel the imported routing information
of other protocols
By default, RIP does not import the route information of other protocol.

3.2.12 Configuring Default Cost for the Imported Route

When using the import-route command to import the routes of other protocols, you
can specify the cost of them. If you do not specify the cost of the imported route, RIP will
set it to the default cost, specified by the default cost parameter.
Perform the following configurations in RIP view.
Table 3-12 Configuring default cost for the imported route
Configure default cost for the imported route
Restore the default cost of the imported route.
By default, the cost value for the RIP imported route is 1.

3.2.13 Setting the RIP Preference

Each kind of routing protocol has its own preference, by which the routing policy will
select the optimal one from the routes of different protocols. The greater the preference
value is, the lower the preference becomes. The preference of RIP can be set
manually.
Perform the following configurations in RIP view.
Table 3-13 Setting the RIP Preference
Set the RIP Preference
Restore the default value of RIP preference
By default, the preference of RIP is 100.
Operation
Operation
Operation
Huawei Technologies Proprietary
3-8
Chapter 3 RIP Configuration
Command
import-route protocol [ cost value ]
[ route-policy route-policy-name ]
undo import-route protocol
Command
default cost value
undo default cost
Command
preference value
undo preference