Auto Detect Configuration Example - Huawei Quidway S3500 Series Operation Manual

Operation Manual - Auto Detecting
Quidway S3500 Series Ethernet Switches
Operation
Specify
timeout time.
Display configurations
of a specified or all
detecting groups.
Note:
The prompts of detecting group views vary with the actual configurations.
Refer to the corresponding command manual for information about parameters
listed in the above table and the related undo commands.

1.1.2 Auto Detect Configuration Example

I. Network requirements
Create a detecting group numbered 10 on Switch A and add two IP addresses in it
to detect the reachability to interfaces with an IP address of 10.1.1.4 and
192.168.2.2.
Specify to return reachable as the detecting result if one of the two interfaces can
be successfully pinged, that is, specify the or keyword for the option command.
Specify the detecting interval to 60 seconds; maximum retries to 3, and the
timeout time to 3 seconds.
II. Network diagram
VLAN 1 VLAN 1
Ethernet 1/0/1 Ethernet 1/0/1
Ethernet 1/0/1 Ethernet 1/0/1
192.168.1.1 192.168.1.1
192.168.1.1/24 192.168.1.1/24
VLAN 2 VLAN 2
Ethernet 2/0/1 Ethernet 2/0/1
Ethernet 2/0/1 Ethernet 2/0/1
192.168.2.1 192.168.2.1
192.168.2.1/24 192.168.2.1/24
Figure 1-1 Network diagram for auto detect
detecting [Quidway-detect-group-X] timer wait
seconds
<Quidway>
[ group-number ]
192.168.1.2/24 192.168.1.2 192.168.1.2/24 192.168.1.2
Switch A Switch A Switch A Switch A
192.168.2.2 192.168.2.2/24 192.168.2.2 192.168.2.2/24
Huawei Technologies Proprietary
1-2
Chapter 1 Configuring Auto Detecting
Command
display detect-group
10.1.1.3 10.1.1.3/24 10.1.1.3 10.1.1.3/24
Switch B Switch B Switch B Switch B
Switch C Switch C Switch C Switch C
Switch D Switch D Switch D Switch D
20.1.1.2 20.1.1.2 20.1.1.2/24 20.1.1.2/24
Remarks
Optional.
Defaults to 2
seconds.
Optional. This
command can
be executed
in any view.
10.1.1.4/24 10.1.1.4 10.1.1.4/24 10.1.1.4