Member Accessing - Huawei Quidway S3500 Series Operation Manual

Operation Manual - Integrated Management
Quidway S3500 Series Ethernet Switches
A member device accesses the configured server through the administrator device.
The cluster members output all log information to the configured log host in the end. A
member outputs and sends the log information to the administrator device directly. The
administrator device translates the log information addresses and sends the log
packets to the cluster log host. Similarly, all the trap packets are output to the cluster
NM host.
You can use the following commands to configure the cluster server and network
management and log hosts.
Perform the following configuration in cluster view.
Table 2-22 Configure FTP /TFTP Servers and Logging/SNMP Hosts for a Cluster
Configure FTP server for the whole cluster.
Remove the FTP server from the cluster.
Configure TFTP server for the whole cluster.
Remove the TFTP server from the cluster.
Configure the logging host for the whole cluster.
Remove the logging host from the whole cluster.
Configure the SNMP host for the whole cluster.
Remove the SNMP host from the whole cluster.
Note that the above command can only be executed on the administrator device.

2.4.12 Member Accessing

A member device in a cluster can be managed through the administrator device. You
can configure a specified member device on administrator device .In order to do this,
you should enter the specified member device view on the administrator device; after
configuration, you can exit the view.
Authorization is required when you want to configure a switch on the administrator
device. Upon passing the member device authorization, the configuration is allowed. If
the user password of the member device is different from the administrator device, you
cannot configure the member device. The user level will be inherited from the
administrator device when you configure the member device on the administrator
device. For example, system will retain in as user view when you configure the member
device on the administrator device.
Authorization is also required when you exit the member device view on the
administrator device. After passing the authorization, the system will enter user view
automatically.
Operation
Huawei Technologies Proprietary
2-17
Chapter 2 HGMP V2 Configuration
Command
ftp-server ip-address
undo ftp-server
tftp-server ip-address
undo tftp-server
logging-host ip-address
undo logging-host
snmp-host ip-address
undo snmp-host