Information Center Configuration - Huawei Quidway S9300 Configuration Manual

Quidway S9300 Terabit Routing Switch
Configuration Guide - Device Management
About This Chapter
This chapter describes how to configure the information center to control the output of logs,
alarms, and debugging messages.
5.1 Introduction to the Information Center
The information center works as the information hub of a switch. It classifies and filters the
output of a system. The information center uses a debugging program to help network
administrator and developers monitor network operation and analyze network faults.
5.2 Information Center Supported by the S9300
In the S9300, the information center outputs logs, alarms, and debugging messages with eight
severity levels to different directions through 10 information channels.
5.3 Enabling Log Output
This section describes how to output logs of a specified module to a log file, console, terminal,
or log host.
5.4 Enabling Alarm Output
You can configure a specific module to output alarm information to log files, consoles, terminals,
or SNMP agents.
5.5 Enabling the Output of Debugging Information
You can configure a specific module to output alarm information to log files, consoles, terminals,
or SNMP agents.
5.6 Maintaining Information Center
This section describes how to run the reset info-center statistics, reset logbuffer, or reset
trapbuffer command to delete messages in the buffer of the information center. Note that deleted
messages cannot be restored.
5.7 Information Center configuration Examples
This section provides configuration of the information center.
Issue 03 (2011-12-29)
5

Information Center Configuration

Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
5 Information Center Configuration
51