Setting Up Configuration Environment Through A Dial-Up The Modem - Huawei Quidway S3000-EI Series Operation Manual

Operation Manual - Getting Started
Quidway S3000-EI Series Ethernet Switches
PC
Figure 2-7 Providing Telnet Client service
S tep 1: Authenticate the Telnet user via the Console port on the Telnet Server (switch)
before login
Note:
By default, the password is required for authenticating the Telnet user to log in the
sw itch. If a user logs in via the Telnet without passwo
password has not been set !".
<Quidway> system-view
[Quidway] user-interface vty 0
[Quidway-ui-vty0] set authentication password simple xxxx (xxxx is the preset
login password of Telnet user)
Step 2: The user logs in the Telnet Client (switch). For the login process, refer to the
section describing "Connecting a PC to the Switch through Telnet".
Step 3: Perform the following operations on the Telnet Client:
<Quidway> telnet xxxx (xxxx can be
Server. If it is the hostname, you need to use the ip host command to specify.)
Step 4: Enter the preset login password and
the prompt "All user interfaces are used, plea
many users are connected to the switch thro
please connect later.
Step 5: Use the corresponding comman
state. Enter "?" to get the immediate help. For details of specific commands, refer to the
following chapters.
2.3 Setting up Configuration Environment through a Dial-up
the Modem
Step 1: Authenticate the Modem user via the Console port of the switch before he logs
in the switch through a dial-up Modem.
Telnet Server
Telnet Client
.
Huawei Technologies Proprietary
rd, he will see the prompt "Login
the hostname or IP address of the Telnet
you will see the prompt such <Quidway>. If
se try later!" appears, it indicates that too
ugh the Telnet at this moment. In this case,
ds to configure the switch or view it running
2-5
Chapter 2 Logging in Switch