REAR SUSPENSION cAWD>
Bolt B
' i i - \ -A
MB991254
TSB Revision
(3) Set the special tool onto the trailing arm as shown in
the illustration.
NOTE
(1) Apply lubricant to the sliding portion of the special
tool (at the arrow marked "A" in the illustration).
(2) Install bolt B to the trailing arm, at the point shown
in the figure.
(4) Use a spanner, etc., to turn the portion marked "C" in
the illustration to remove the connecting rod.
(5) Installation of the body (special tool) should be performed
with the screw shaft and guide shaft center lines oriented
as shown in the illustration.
(6) ",pdp'y soapy water to the rubber portion of the connecting
(7) Reverse the removal procedures to press-fit.
(8) Remove the special tool after aligning the holes in the
special tool and trailing arm.
(9) Tighten the bolts and nuts to the specified torque.
Tightening torque : 98 Nm (71 ft.lbs.)