Mitsubishi 3000GT Service Manual page 957

MB990
i i
I
PARKING BRAKES
With the special tool, secure the axle shaft and tighten the
companion flange self-locking nut.
After tightening the flange nut, align with the spindle's
indentation and crimp.
Spindle
z
Insert a filler gauge between the speed sensor pole piece
and rotor teeth and tighten the speed sensor at such position
where the gap is as specified below over the entire
circumference.
Standard value: 0.2-O-7 mm (.008-.028 in.)
INSPECTION
CHECKING FOR UNUSUAL WEAR OF THE BRAKE
LINING AND BRAKE DRUM
(1) Measure the thickness of the brake lining at several places.
Standard value: 2.8 mm (.llO in.)
Limit: 1.0 mm (.039 in.)
Caution
Replace the brake shoes if the thickness of the brake
lining is the limit value or less.
(2) Measure the brake disc drum inner diameter at two or
more places.
Standard value: 168.0 mm (6.6 in.)
Limit: 169.0 mm (6.7 in.)
Caution
Replace if the brake disc drum inner diameter is the
limit value or more.