I
Rear
Motor
Limit switch
I
-
EXTERIOR - Aero Parts
REMOVAL SERVICE POINT
Remove the side air dam by the same procedure as the
side garnish. (Refer to P.51-15.)
INSTALLATION SERVICE POINTS
Install the air dam link assembly in the operative condition
for ease of front under cover panel.
Front
Install the side air dam by the same procedure as the side
garnish (refer to P.51-15), provided that specified adhesive
is used.
Specified adhesive:
3M ATD Part No. 8609 SUPER FAST URETHAN or
equivalent
INSPECTION
1. REAR SPOILER MOTOR AND LIMIT SWITCH
CHECK
(1) Connect the battery as shown in the illustration to make
sure that the motor and spoiler operate freely. Then
connect the battery with the reversed polarity to make
sure that the motor and spoiler operate freely.
(2) While performing the inspection described in (1) above,
check the limit switch for continuity.
Spoiler position
During operation
SLANT (operative position)
_
_
-
TSB Revision
51-21
Terminal No.
3
4
5
0
0
0
0
0
0