AUTOMATIC TRANSAXLE
Screwdriver
Lever
assembly
DISASSEMBLY SERVICE POINTS
Terminal
REMOVAL
Disconnect the overdrive control switch connector and then
remove the terminal from the overdrive control switch
connector.
OVERDRIVE CONTROL SWITCH REMOVAL
(1) Using the flat-tip screwdriver, remove the overdrive control
switch button.
(2) Remove the overdrive control switch mounting screw.
(3) Pressing the switch, remove the overdrive control switch.
REASSEMBLY SERVICE POINT
Sleeve
,A( SLEEVE INSTALLATION
Place the selector lever in the "N" position, and then turn
the sleeve so that the clearance between the sleeve and
the lever assembly end is within the standard value.
A
Standard value (A): 15.2-15.9 mm (.598-.625 in.)
INSPECTION
Check the detent plate for wear.
l
Check the bushing for wear or damage.
l
Check the spring for damage or deterioration.
l
POWER (PWR)/ECONOMY (ECO)/HOLD (HOLD)
SWITCH CHECK
Check for continuity between terminals when the switch is
OFF and when ON.
TSB Revision