Mitsubishi 3000GT Service Manual page 1186

and turn the ignition key to the "ON
terminal (of SRS Check Harness con-
(ground) indicate system voltage?
NOTE - IMPORTANT
(1) If more than 45 seconds of cranking is required to start up the engine, the diagnostic trouble
code will be stored in memory, but if there is no problem, the diagnostic trouble code will
be cleared and the SRS will return to normal.
(2) After repairing the SRS, reconnect the battery cable, erase the diagnostic trouble code memory
from the scan tool (1992 model) and check the SRS warning light operation to verify the system
functions properly. (Refer to TEST 1.)
(3) SDU = SRS Diagnosis Unit
SRS - Troubleshooting
No
Malfunction of the SDU
Short-circuit of cranking-signal detec-
tion circuit wiring harness and power
source
TSB Revision
Repair or replace harness.
(Refer to P.52B-16, 20.)
(Refer to P.52B-71.)
(1) Turn the ignition key to the "LOCK"
position, disconnect the negative
battery cable and tape the terminal.
(2)After waiting at least 60 seconds,
repair or replace the body wiring har-
ness. (Refer to P52B-16, 20.)
1