Mitsubishi 3000GT Service Manual page 813

REAR SUSU'ENSION cAWD> - Rear Suspension Assembly
Press out
MB991 387
MB991 388
REMOVAL SERVICE POINTS
MOUNTING NUT (ON DIFFERENTIAL SIDE) /
REAR SUSPENSION ASSEMBLY REMOVAL
(1) Before removing the crossmember bracket, support the
differential case with the transmission jack.
(2) Remove the crossmember mounting bolt and nut.
NOTE
Lowering the rear suspension assembly down from the
transmission jack requires three persons, as the rear
suspension assembly is very heavy. (Assign one person
to the differential and one each to the left and right lower
arm.)
(3) Apply a wood block to the ball joint of the lower arm
to prevent the dust shield from being deformed.
INSPECTION
Check the crossmember for cracks or deformation.
l
Check the bushings for cracks or deterioration.
l
CROSSMEMBER SUPPORT BUSHING (FRONT)
REPLACEMENT
(1) Using the special tool, remove and press-fit the crossmem-
ber support bushing.
(2) When press-fitting the bushing, make sure that the hollow
portions are positioned as shown.
NOTE
Ensure that the shift in rotating direction is within So.
TSB Revision