mm (in.)
Cut off nozzle tip
Section A
<Vehicles with sun roof>
Adhesive
12 (.4j)
Section B
Adhesive
Section C '("')
55 (2.17)
mm (in.)
BODY - Windshield
(6) Within 30 minutes of primer application, apply the adhesive
all around the windshield glass uniformly.
Adhesive:
NOTE
Cutting the nozzle tip of the sealant gun to a V-shape
will help application.
(7) Install the windshield moulding.
J
(8) After application of the adhesive, line up the match-marks
on the glass and body and force the glass lightly and
evenly onto the body for complete fitting.
(9) Remove adhesive from around and on the glass and
body surfaces using a spatula and wipe the surfaces
clean.
(lO)After the work (installation of the glass), allow to stand
until the adhesive hardens.
Caution
If an infrared lamp or other means are used for quicker
hardening, keep the surface temperature 60°C (140°F)
or lower.
windshield glass to the body, check for water leaks.
Caution
1. If the vehicle is to be moved, do so gently.
2. When checking for water leaks, do not apply water
Windshield
glass
TSB Revision
3M SUPER FAST URETHAN 8609 or equivalent
with the hose end squeezed.