Driver's side
<From 1994 models>
Con
Passenger's side
Connector
SRS
(2) Reconnect the negative battery terminal. Turn the ignition
switch to "ON". Does the "SRS" warning light illuminate
for about 7 seconds, turn OFF and then remain OFF
for at least 45 seconds? If yes, SRS system is functioning
properly. If no, consult page 528-23.
INSPECTION
AIR BAG MODULE CHECK
If any improper part is found during the following inspection,
replace the air bag module with a new one.
Dispose of the old one according to the specified procedure.
(Refer to P.52B-82-P.52B-87.)
Caution
or case
Never attempt to measure the circuit resistance of the
air bag module (squib) even if you are using the specified
tester. If the circuit resistance is measured with a tester,
accidental air bag deployment will result in serious per-
sonal injury.
(1) Check pad cover for dents, cracks or deformities.
Inflator
(2) Check the air bag module for dents, cracking or deforma-
se
tion.
(3) Check hooks and connectors for damage, terminals for
deformities, and harness for binds.
(4) Check air bag inflator case for dents, cracks or deformities.
00002585
(5) Install the air bag module on the steering wheel to check
alignment with the wheel.
Caution
If a dent, crack or other deformation is discovered,
replace the air bag module with a new one. Dispose
of the old one according to the specified procedure.
(Refer to PS2B-82 to P.!52B-87.)