Mitsubishi 3000GT Service Manual page 1036

BODY
Remove windshield using the following procedure.
(1) For protection of the body (coated surface), apply cloth
(2) Using a drill of sharp bit, drill a hole through the adhesive
(3) Run a wire through the hole from inside of the
(4) Pull the wire alternately from inside and outside of the
(5) Put matchmarks on the body and the glass.
(6) Using the special tool, remove the windshield glass.
Matchmarks
(7) Using a sharp knife, scoop out existing adhesive from
(8) Finish smooth the flange surfaces.
(9) If the glass is reused, scoop out existing adhesive and
(lO)Degrease the body same way.
TSB Revision
REMOVAL SERVICE POINT
tape to all around the body where the glass is installed.
fixing the windshield glass.
compartment.
compartment to cut off the adhesive.
Caution
Be careful to prevent contact of the wire with the
windshield glass edge.
the body flange to 2 mm (.08 in.) or less thickness all
around the window opening.
Caution
1. Do not remove the adhesive more than necessary.
2. Be careful not to damage the coated surface of
the body with the knife. If it is damaged, apply
retouch paint of anti-corrosive.
fragments of the window dam completely from the glass
and degrease with 3M ATD Part No. 8906 or equivalent.
Caution
After degreasing, allow three minutes or more to dry
well before next work. Do not touch the degreased
surface.