PROPELLER SHAFT
Cage
Inner race
TSB Revision
(2) Put mating marks on the outer race, cage and inner race
with a scriber before removing the outer race and balls.
Caution
Note the positions of balls so that they can be
reinstalled in their original positions.
(3) Remove the inner race with cage from the center propeller
shaft by using a puller (commercially available).
NOTE
When changing the grease on the Lobro joint assembly,
wipe off the grease and clean the outer and inner races,
cage and balls.
(4) If the outer race cannot be removed, remove the complete
Lobro joint assembly from the center propeller shaft by
using a puller (commercially available).
Tape the serration of the center propeller shaft and then
remove the Lobro joint boot.
Put mating marks on the companion flange and the rear
propeller shaft before removing the companion flange.
Shaft