Mitsubishi 3000GT Service Manual page 1267

HEATERS AND MANUAL
AIR CONDITIONING
Move the radiator toward the engine, and then remove the
condenser upward.
INSTALLATION SERVICE POINT
If a new condenser is used, fill it with the specified amount
of compressor oil before installing on the vehicle.
Compressor oil:
Quantity: 15 cm3 (S fl.02.)
INSPECTION
l
l
l
CONDENSER FAN MOTOR CHECK
(1) Apply battery voltage (+) to terminal (3) and ground (-)
(2) Apply battery voltage (+) to terminal (1) and ground (-)
FREOL S-83 or SUNISO 5GS <Vehicles using R-12
refrigerants
SUN PAG 56 <Vehicles using R-134a refrigerant>
Check the condenser fan for crushing or other damage.
Check the condenser's discharge hose and pipe installa-
tion parts for damage or deformation.
Check the condenser fan shroud for damage.
terminal (4); at this time, check that the condenser fan
motor turns.
terminal (2); at this time, check that the condenser fan
motor turns.