Mitsubishi 3000GT Service Manual page 656

AUTOMATIC TRANSAXLE
(2) Remove the nut and move the bolt so that a spanner
Refer to GROUP 22 - Manual Transaxle.
bracket installation
Refer to GROUP 22 - Manual Transaxle.
(1) Support the transaxle assembly with the transaxle jack.
(2) Rotating the crankshaft, remove the special bolts at four
(3) After removing the special bolts, push the torque converter
(4) Remove coupling bolt at the bottom of transaxle assembly
INSTALLATION SERVICE POINTS
Attach the torque converter on the transaxle side and mount
the transaxle assembly on the engine.
Caution
If the torque converter is mounted first on the engine,
the oil seal on the transaxle side may be damaged.
Therefore, be sure to first assemble the torque converter
on the transaxle side.
Refer to GROUP 22 - Manual Transaxle.
(1) Connect the transaxle control cable to the manual control
(2) Loosen the nut, pull the transaxle control cable lightly
can be applied to the transaxle mount bracket mounting
bolt; then, remove the transaxle mount bracket mounting
bolt.
DISCONNECTION
ASSEMBLY / DRIVE SHAFT (RIGHT SIDE)
REMOVAL
LOWER PART COUPLING BOLT / TRANSAXLE
ASSEMBLY REMOVAL
places.
toward transaxle so that it does not remain on the engine
side.
and lower the transaxle assembly.
lever and tighten the nut temporarily.
in the arrow direction and retighten the nut.