Mitsubishi 3000GT Service Manual page 1100

EXTERIOR - Rear Wiper and Washer
(2) Operate the switch to check for continuity between the
terminals.
0 0 0 0 2 3 4 4
INTERMITTENT WIPER RELAY CHECK
(1) Remove the quarter trim. (Refer to GROUP 52A - Trims.)
(2) With the intermittent
'harness connector, let the wiper operate intermittently
and check the voltage at terminal (2).
I
When wiper is in operation
WASHER MOTOR CHECK
(1) When the washer motor is inspected, make sure that
it is mounted on the washer tank and that the washer
tank is filled with water.
(2) Connect the battery as shown to check whether water
is pumped out.
TSB Revision
wiper relay connected to the wiring
Condition Standard
I