NO COMMUNICATION BETWEEN SCAN TOOL AND SDU
IGNITION tWKH(IGl~
Battery
SRS - Troubleshooting
To front impact sensor (L.H.)"
or unused terminaF2
(1) Turn the ignition key to the "LOCK" position, disconnect
the negative battery cable and tape the terminal.
Caution
Wait at least 60 seconds after disconnecting the bat-
tery cable before doing any further work. The SRS
system is designed to retain enough voltage to deploy
the air bag even after the battery has been discon-
nected. Serious injury may result from unintended
air bag deployment if work is done on the SRS system
immediately after the battery cable is disconnected.
(2) Remove the rear console assembly. (Refer to GROUP
SRS diagnosis unit
View A
To front impact sensor (R.H.)*'
or to passengers airbag module*2
To c&k spring
To body wiring harness (14-pin)
NOTE
I
,
00002607