Mitsubishi 3000GT Service Manual page 1189

L o c k
I
MB991349 (Up to 1993 models)
MB991 530 (From 1994 models)
SRS Check Harness
View A
SRS Check Harness Connector (5)
SRS - Troubleshootina
(3) Release the lock of SDU connector in accordance with
the following procedure:
In case that there is no notch on the lock lever
Place a flat tip screwdriver against the lock spring (metal
section) of the connector lock lever as shown in the illustra-
tion, and push the spring horizontally toward the inside
of the unit.
Caution
Do
1.
2. Do not insert the screwdriver into the gap between
the lock lever and the lock spring.
In case that there is a notch on the lock lever
Place a flat tip screwdriver against the lock spring (metal
section) at the lock lever notch as shown in the illustration,
and push the spring toward the unit.
Caution
Do not use excessive force to raise the lock lever.
(4) Disconnect the red 14-pin connector from the SDU.
(5) Connect the now disconnected red harness-side SDU
connector (14-pin) to the connector (3) of the SRS Check
Harness.
(6) Check according to the flow chart on the next page, using
the specified digital multi-meter.
Fuse No. 1 1
not use excessive force to raise the lock lever.