Mitsubishi 3000GT Service Manual page 686

FRONT AXLE
REASSEMBLY SERVICE POINTS
INSTALLATION
(1) Wrap vinyl tape around the splines on the drive shaft,
and then install the R.J. boots and T.J. boots, in that
order.
(2) Fill the inside of the B.J. and B.J. boot with the specified
I
grease.
Specified grease:
Repair kit grease
Caution
1. The grease in the repair kit should be divided
in half for use, respectively, at the joint and inside
the boot.
2. Special grease is used to lubricate the joint. Do
not mix old and new grease or different types
of grease.
(3) Secure the boot bands.
Caution
1. The boot bands should be tightened with the drive
shaft at a 0" joint angle.
2. The B.J. boot band and T.J. boot band are identified
by the identification number stamped on the lever.
Take good care to install the correct one.
Pack specified grease amply between the spider shaft
(1)
and rollers of the spider assembly.
Specified grease: Repair kit grease
Caution
Special grease is used to lubricate the joint. Do not
mix old and new grease or different types of grease.
(2) To install the spider assembly to the shaft, insert the
shaft from the chamfered end of the spider.
TSB Revision