Mitsubishi 3000GT Service Manual page 941

SERVICE BRAKES -
Caution
When removing the speed sensor from the knuckle, be
careful not to strike the tip of the pole piece against the
rotor teeth or any other parts.
INSTALLATION SERVICE POINTS
Insert a feeler gauge between the speed sensor pole piece
and the rotor tooth surface and tighten the speed sensor
to specified torque where the clearance is as specified all
around.
Standard value: 0.2-0.7 mm (.008-.028 in.)
NOTE
The rear speed sensor pole piece-to-rotor tooth surface clear-
ance is not adjustable in the case of AWD vehicles. In this
case, measure the sensor mounting surface-to-rotor tooth
surface clearance.
Standard value: 28.15-28.45 mm (1.11-1.12 in.)
NOTE
(1) The right and left speed sensor brackets differ in shape.
(2) After installation of the speed sensor to the bracket, check
Caution
Handle the speed sensor carefully so as not to strike
the tip of the pole piece or the rotor teeth against any
metal parts and damage them.
Insert a feeler gauge between the speed sensor pole piece
and rotor tooth surface and tighten the speed sensor to speci-
fied torque where the clearance is as specified all around.
Standard value: 0.3-O-9 mm (.012-.035 in.)
TSB Revision
Wheel Speed Sensor CABS>
SENSOR REMOVAL
INSTALLATION
Install correctly referring to the identification symbols.
FR: For front speed sensor
R: For right wheel
L: For left wheel
that the letters "FR" are visible.