Mitsubishi 3000GT Service Manual page 537

Vehicles wiiho& -
auto-cruise
auto-cruise con-
control system
trol system
Lock nut
Clutch pedal
position switch
Lock nut
CLUTCH
CLUTCH PEDAL CHECK AND ADJUSTMENT
1. Take off the carpet at under the clutch pedal. Measure
the clutch pedal height (from the face of the pedal pad
to the firewall).
If the clutch pedal height is not within the standard value
range, adjust as follows:
For vehicles without auto-cruise control system, turn and
adjust the bolt so that the pedal height is the standard
Lock nut
value, and then secure by tightening the lock nut to the
specified torque.
Vehicles with auto-cruise control system, disconnect the
clutch pedal position switch connector and turn the switch
for standard clutch pedal height. Tighten the lock nut
When the pedal height is lower than the standard value,
loosen the bolt or clutch pedal position switch, and then
turn the push rod to make the adjustment. After making
the adjustment, tighten the bolt or clutch pedal position
switch to reach the pedal stopper, and then lock with
the lock nut.
2. Measure the clutch pedal stroke.
If the clutch pedal stroke deviates from the standard value,
turn the push rod to adjust the stroke.
3. Return the clutch pedal gradually from its full-stroke posi-
tion to measure amount of the return made by the pedal
until, the interlock switch makes an operating sound.
If the amount of pedal return deviates from the standard
value, adjust it by loosening the lock nut and turning
the interlock switch.