Mitsubishi 3000GT Service Manual page 568

MANUAL TRANSAXLE cFWD> - Transaxle Assemblv
jack
Transaxle
mount \
bracket
(1) To remove drive shaft (right side) from transaxle assembly,
apply pry bar to the protrusion.
NOTE
Remove drive shaft (right side) as an assembly together
with hub, knuckle, and other parts.
(2) Suspend the removed drive shaft (right side) with wire
or something similar to prevent it from sharply bending
or turning at each joint.
Support transaxle assembly with a transaxle jack and remove
transaxle assembly lower part coupling bolt; then, lower trans-
axle assembly.
INSTALLATION SERVICE POINTS
Provisionally install the drive shaft (right side) so that the
inboard joint part of the drive shaft (right side) is straight,
and not bent relative to the transaxle.
Install mounting stopper in the direction shown.