Mitsubishi 3000GT Service Manual page 563

MANUAL TRANSAXLE <FWD>
Neutral position
Shift lever
Adjuster
Lever B ooooi53o
I
INSTALLATION SERVICE POINTS
(1) Move the transaxle shift lever to the neutral position.
NOTE
The select lever will be set to the neutral position when
the transaxle shift lever is moved to the neutral position.
(2) With the shift lever on the passenger compartment side
in the neutral position, turn adjuster on select cable so
that select cable end is positioned as shown with reference
to lever B of shift lever.
(3) Install the select cable so that the flange side of the
plastic bushing at the end of select cable is on the end
face side of lever B.
(4) Turn adjuster on shift cable so that shift cable end is
positioned as shown with reference to shift lever on the
passenger compartment side.
(5) Install the shift cable so that the flange side of the plastic
bushing at the end of shift cable is on the split pin side.
(6) Connect the shift cable, then turn adjuster on shift cable
so that dimension A equals dimension B.
(7) Move the shift lever to each position and check that the
shifting is smooth.
INSPECTION
Check the transaxle control cable assembly for function
l
and for damage.
Check the boot for damage.
l
Check each bushing for wear or abrasion, sticking, imped-
l
ed action, and damage.