Grommet
REMOVAL AND INSTALLATION
Pre-removal and Post-installation Operation
Rear End Trim and Rear Side Trim Removal and Instal-
l
lation (Refer to GROUP 528 - Trims.)
Removal steps
1. Rear combination light
2. Rear panel garnish
3. Bolts
4. License plate light
EXTERIOR
REAR BUMPER
Installation
REMOVAL AND INSTALLATION OF CLIP WITH
SCREW
Normally, remove the clip with a Phillips screwdriver. If, howev-
er, there is enough space to insert a screwdriver or the like
behind the clip, use the following procedure for ease of work.
1. Removal
Using a screwdriver or the like, press the screw from the
00002334
inside of the bumper to remove the clip.
2. Installation
With the grommet inserted in the hole, press the screw in.
TSB Revision
ECS Control Unit Removal and Installation (Refer to
l
GROUP 338 - ECS Control Unit.)
8. Bolts
9. Bumper face upper plate
10. Bumper face assembly
11. Rear bumper upper extension
12. Rear bumper harness connector
13. Nuts
14. Bumper reinforcement assembly