Mitsubishi 3000GT Service Manual page 1122

Position A Position B
Nut housing
Lower rail
TSB Revision
INTERIOR - Front Seat
FRONT SEAT ASSEMBLY REMOVAL AND
INSTALLATION POINTS WHEN THERE IS A
MALFUNCTION IN THE POWER SEAT SLIDE
MECHANISM
If removal of the seat mounting nut and bolt is impossible
when there is a malfunction in the slide motor or the slide
switch and the seat cannot slide, remove and install the front
seat assembly by the following procedure.
In addition, two removed and installation procedures are estab-
lished depending on the seat positions.
Position A shown in the illustration - Refer to procedure.
l
l
2.
1. Procedure for removal and installation of seat
stopped at forward position
(1) Working from behind the seat, remove the bolt from under
the seat cushion as illustrated.
(2) Insert a flat tip screwdriver between the plate and the
nut housing, pry the pawl of the nut housing from the
hole of the plate and rotate the housing.
(3) Slide the seat and remove the seat mounting nuts and
bolts.
(4) When the power seat adjuster assembly is reused, apply
specified adhesive to the mounting bolts before, tightening
them.
Specified adhesive:
3M stud locking 4171 or equivalent.
Caution
Be sure that the right and left nut housing are in align-
ment.
2. Procedure for removal and installation of seat
stopped at rearward position
(1) Take off the seat cover from the front end of the seat
cushion.
,