I
there continuity between the No. 19 or No. 20 - Ground circuit open
S
terminal of SRS Check Harness connector (5) and
ground?
Reconnect negative terminal of battery, and turn
the ignition key to the 'ON" position.
NOTE - IMPORTANT
(1) After repairing the SRS, reconnect the battery cable, erase the diagnostic trouble code memory
from the scan tool and check the SRS warning light operation to verify the system functions
properly. (Refer to TEST 1.)
(2) SDU = SRS Diagnosis Unit
SRS - Troubleshooting
N o
TSB Revision
(l)Tum the ignition key
to the "LOCK" position,
disconnect the nega-
tive battery cable and
tape the terminal.
(2)After waiting at least
80 seconds, repair or
harness. (Reier to
to the "LOCK" position,
disconnect the nega-
tive battery cable and
tape the terminal.
(2)After waiting at least
60 seconds, replace
the SDU. (Refer to