REAR SUSPENSION <FWD>
Coil sprin
Lower bushing inner pipe
REASSEMBLY SERVICE POINTS
(1) Use the special tool (MB991237 and MB991239) to
compress the coil spring and insert it in the shock absorber.
(2) Align the edge of the coil spring to the position of the
shock absorber spring seat as shown.
TIGHTENING NUT INSTALLATION
(1) With the position of the bracket assembly as shown in
the figure, tighten the tightening nut to the specified torque.
(2) Install the coil spring so that the lower edge fits into the
spring seat groove and the upper edge fits into the spring
pad groove, then remove the special tool (MB991237
and MB991 239).
INSPECTION
Check the rubber parts for damage.
l
Check the coil springs for crack, damage or deterioration.
l