Mitsubishi 3000GT Service Manual page 1263

HEATERS AND MANUAL AIR CONDITIONING
Fitting block
ront housing t20Noo3(
Snap-ring
Clutch coil
Clutch coil
Tapered part
Crankshaft
DISASSEMBLY SERVICE POINTS
Use the special tool to loosen the nut.
SENSOR REMOVAL
(1) Remove the fitting block from the compressor.
(2) Remove the snap ring from inside the fitting block and
remove the refrigerant temperature switch.
(3) Remove the revolution pick-up sensor from the fitting
block.
REASSEMBLY SERVICE POINTS
Align the pin of the clutch coil with the pin hole in the front
housing, and then fit it into the hole.
Install the snap ring so that the tapered surface is at the
outer side.
Align the mating mark of the crankshaft spline and the mating
mark of the armature plate, and then fit them together.
TSB Revision
55-43