Mitsubishi 3000GT Service Manual page 641

AUTOMATIC TRANSAXLE - On-vehicle Service
r---Push button
brake pedal is depressed)
ACCELERATOR SWITCH CHECK AND
ADJUSTMENT (1992 model)
Check that current flows between terminals of accelerator
switch when accelerator pedal is in free state and that no
current flows when the pedal is depressed and the specified
stroke A is obtained.
Standard value: 2-6 mm (.079-.24 in.)
If stroke A is out of specification, adjust with adjusting bolt.
SELECTOR LEVER OPERATION CHECK
Shift selector lever to each range and check that lever
1.
moves smoothly and clicks into position. Check that posi-
tion indicator is correct.
2. Check to be sure the selector lever can be shifted to
each position (by button operation as shown in the illustra-
tion).
3. Start the engine and check if the vehicle moves forward
when the selector lever is shifted from N to D, and moves
backward when shifted to R.
4. When the shift lever malfunctions, adjust control cable
and selector lever sleeve. Check for worn shift lever as-
sembly sliding parts.
NOTE
To move the selector lever from the "p,l position to any
other position, first turn the ignition key to any position
other than "LOCK" and depress the brake pedal.
KEY INTERLOCK MECHANISM CHECK
. Completely stop the vehicle and switch OFF the engine before
making the check
1. Check to be sure that, under the following conditions,
the selector lever cannot be moved from the "P" position
to any other position.
Also check, at the same time, that the button cannot
be pressed.
Ignition key position: "LOCK" or removed
Brake pedal: Depressed
TSB Revision