Mitsubishi 3000GT Service Manual page 642

AUTOMATIC TRANSAXLE - On-vehicle Service
Push button
Brake
Brake
TSB
2. Check to be sure that, under the following conditions,
the selector lever can be moved from the "P" position
to any other position.
Press the button a few times and check to be sure that
the selector lever moves smoothly.
Ignition key position:
Brake pedal: Depressed
Button: Pressed
3. Check to be sure that, at all positions of the selector
lever (other than "P"), the ignition key cannot be turned
to the "LOCK" position.
Check to be sure that the ignition key smoothly turns
to the "LOCK" position when the selector lever is then
set to the "P" position and the button is released.
4. If above are not checked okay, adjust key interlock cable
mechanism as follows.
(1) Remove front console assembly.
(2) Place selector lever into "P position.
(3) Turn ignition key to the "LOCK" position.
(4) Loosen nut that secures key interlock cable.
(5) Lightly pressing lock cam A in the direction of arrow,
lightly push key interlock cable to take up slack and
tighten nut to secure key interlock cable.
(6) Reinstall front console assembly.
SHIFT LOCK MECHANISM CHECK
1. Check to be sure that, under the following conditions,
the selector lever cannot be moved from the "P" position
to any other position.
Ignition key position: "ACC"
Brake pedal: Not depressed
Button: Pressed
2.
Check to be sure that, under the following conditions,
the selector lever can be moved smoothly from 'the "P"
position to any other position.
Ignition key position:
Brake pedal: Depressed
Button: Pressed
3. Check to be sure that, under the following conditions,
the selector lever can be moved smoothly from the "R"
position to the "P" position.
Ignition key position: "ACC"
Brake pedal: Released
Button: Pressed
4. If a malfunction is discovered when following the above
checking procedures, either adjust or check the shift lock
cable mechanism.
Revision
"ACC"
"ACC"