Mitsubishi 3000GT Service Manual page 782

ECS
(4) Depress the brake pedal and simultaneously change the
entered simulated vehicle speed by the scan tool. (Change
the speed in 0.4 seconds after depressing the brake ped-
al.)
(5) Using the scan tool, check that the indications of service
data items No. 61 through 64 change over.
Changing entered simulated
(6) Check that the original damping force indication (SOFT)
is restored a second later.
5-3. Anti-Squat Control Function Check
(1) Select the Tour mode by the ECS switch.
(2) Enter a simulated vehicle speed of 30 km/h (19 mph)
from the scan tool.
(3) Using the scan tool, check the indications of service data
items No. 61 through 64.
Scan tool indication: SOFT
(4) Check that when the accelerator pedal is operated, the
indications of service data items No. 61 through 64 on
the scan tool change as shown in the following table.
(5) With the simulated vehicle speed at 60 km/h (37 mph)
and 90 km/h (56 mph), similarly operate the accelerator
pedal and check that the scan tool indications change
over.
Entered simulated
vehicle speed
km/h (mph)
I 30 (19)
(6) Check that when the accelerator pedal is released, the
original damping force (SOFT) is restored in less than
a second.
5-4. High Speed Sensitive Control Function Check
(1) Select the Tour mode by the ECS switch.
(2) Check that when the entered simulated vehicle speed
is changed by the scan tool, the indications of service
data items No. 61 through 64 change.
(If the simulated vehicle speed is continuously changed
by the fixed function keys of the scan tool, however, the
indications of service data items No. 61 through 64 do
not change during the period the fixed function key is
pressed.)
Changing entered simulated vehicle speed
Acceleration 129 km/h (80 mph) to 130 km/h 1 SOFT + MEDIUM
Deceleration 120 km/h (75 mph) to 119 km/h
(74 mob)
TSB Revision
vehicle soeed
Accelerator operating condition
Quickly
depress
Scan tool
indication
A second later with
I
I
Scan tool
indication I
MEDIUM + SOFT