Mitsubishi 3000GT Service Manual page 1218

SRS - Air Bag Module Disposal Procedures
Wires
Connection
Insulation
SRS AIR BAG
ADAPTER
Two wires
Air bag module
Used tires
without wheel
Wires
6. Stuck three used tires without wheel, on the tire to
which the air bag module has been secured.
<Passenger's side>
1. Remove the passenger's air bag module.
(Refer to P.52B-75.)
Caution
The air bag module should be stored on a flat
surface and placed so that the pad cover face
up. Do not place anything on top of it.
2. Connect two wires each six meters (20 feet) long
or more, to the two leads of SRS AIR BAG ADAPTER
HARNESS A and cover the connections with insula-
tion tape. The other ends of the two wires should
be connected to each other (short-circuited), to pre-
vent sudden unexpected deployment of the air bag.
3. Connect, the deployment wires to the SRS air bag
adaptor harness A, pass it beneath the tire and wheel
assembly, and connect it to the air bag module.
4. Pass the thick wires into the hole of the air bag module
bracket, and secure it to the wheel of the old tire
with wheel (4 locations), with the air bag facing up-
wards.
Caution
1. Leave some space below the wheel for the
deployment wires.
If there is no space, the reaction of the air
bag deployment could result in damage of
the adaptor harness.
2. While deployment takes place, do not have
the connector of the SRS air bag adaptor har-
ness A inserted between the tires.
5. Place three old tires without wheels on top of the
tire secured to the air bag module, and secure all
tires with ropes (4 locations).