Mitsubishi 3000GT Service Manual page 985

MB990927
Vent hole
Oil seal
MB991213
Back-up washer
I Z13R02'
STEERING - Power Steering Gear Box
Use the special tools to press fit ball bearing.
(1) Apply 'a coating of the specified fluid to the outside of
the oil seal and O-ring.
Specified fluid:
Automatic transmission fluid "DEXRON II"
(2) Using the special tool, press fit oil seal until it touches
-ring
rack bush end.
(1) Apply a coating of multipurpose grease to the rack teeth
face.
Caution
Do not close the vent hole in the rack with grease.
(2) Cover rack serrations with special tool.
(3) Apply specified fluid on special tool.
Specified fluid:
Automatic transmission fluid "DEXRON II"
(4) Match oil seal center with rack to prevent retainer spring
from slipping and slowly insert rack from power cylinder
side.
21360147
Wrap the rack end with vinyl tape, apply a coating of the
specified fluid, and then install the rack bushing and rack
stopper.
Specified fluid:
Automatic transmission fluid "DEXRON II"
Caution
Do not allow oil seal retainer spring to slip out.
TSB Revision