REAR SUSPENSION <AWD>
Press out
(3) Make sure that the protrusion of the inner sleeve (dimen-
sion A and B) are up to specifications.
Standard value
Dimension A: 15.5 mm (59 in.)
Dimension B: 2.1-3.7 mm (.08-.15 in.)
CROSSMEMBER BUSHING (REAR)
REPLACEMENT
(1) Using the special tool, remove and press-fit the bushing.
(2) When press-fitting, position the bushing as shown.
NOTE
Ensure that the shift in rotating direction is within +5".
(3) Make sure that the protrusion of the inner sleeve (dimen-
sion A) is up to specification.
Standard value (A) : 6.7-7.3 mm (.26-.29 in.)
I